Sewing on and Serging forward

Yes, you read it correctly. I have gone and added a new YDK motor to my Singer 99K. Now both of my vintage machines are motor driven! I have to say that since I swapped my first YDK motor from the 99K to the 201, the 201 has been in almost daily use and it has performed flawlessly. It was a good move on my part back in June, but I really felt that the 99K should be motor driven, as it was when I first bought it (even though the original wiring was in a dangerous state.) So I took the plunge and went for a second motor, received it a couple of days ago and put it straight on the 99K. Like before, it runs very well, but is considerably more noisy than the almost silent 201. I think I have found an issue that is adding to the noise. The tension spring is hitting the thread guide below the take up arm as the spring flicks back and forth. If I can fix this (may need a new tension spring) the noise level will drop considerably. Fingers crossed!!

A couple of weeks ago I came across a Kimono Tutorial video on YouTube from YouTuber, Peppermint Milk. It looked pretty straightforward, gave all the pattern dimensions need, and only needed a couple of yards of material. I had some knit fabric that I obtained from my local "scrap store". It was easily long enough but it had a large flaw running across the width which I needed to avoid if I were to have a successful make. I drew up the pattern on brown wrapping paper, just three pieces, laid it out on the fabric and was able to miss the flawed section of fabric with a little juggling of pieces. Pheeeeeew ......... Once I had the pieces cut out I followed much of the construction in Peppermint Milk's YouTube video, using my Toyota 3304 overlocker to do the sleeves, shoulder and side seams, using a 4 thread overlock. I pressed as I went to keep everything neat. Once all the pieces were attached together I decided that the kimono needed a different finish to the neck